Call or email us for an actual copy of our PM reports.

DOORS:

• Inspect: All rollers, bearings, cables, chains, shafts, track, slats, end locks, bottom bars and alignment as applicable
• Adjust: All spring counterbalance assemblies, level of door and track spacing
• Lubricate: Counterbalance shaft bearings, rollers, hinges, chain hoists, bearings and disconnects, etc.
• Tighten: Hardware including hinges, couplings, drums, track brackets and hangers

OPERATORS:

• Inspect: Operator bearings, disconnect linkage & ropes, chain hoist assemblies, safety equipment, treadle hoses and related controls, as applicable
• Adjust: Clutch, brake, and limit assemblies as necessary
• Lubricate: Bearings, chains, gear reducers, disconnects, and pivot points, etc.
• Tighten: Sprockets, brake solenoids, draw-bar arms and hook-ups, etc.

DOCK LEVELERS:

• Inspect: Hold down unit, springs, lip assist, rear hinges, lip assembly, hydraulic hoses and connections, as applicable
• Adjust: Deck counterbalances, lip assembly, hold down unit, and linkage, as necessary
• Lubricate: All pivot points, rear hinges, lip hinge, and shaft, etc.
• Tighten: Linkage fasteners and cable clamps, if needed.

VEHICLE RESTRAINT:

• Clear debris from around restraint
• Inspect restraint mechanism for worn/damaged components
• Lubricate where indicated
• Inspect light communication system for inoperative bulbs and replace where necessary